The drawing of the break bracket given to me
The Process
First I made the out side circles and connected them with the tangent tool. Then I cut out everything that was irrelevant to the bracket. Lastly I made the inner circles.
Now I made to more circles at the top that were the same size as the top 2 outer circles. Then I cut part of the rounded area off.
Its hard to see here but next I made the top 2 inner circles again so that there was a hole all the way through the bracket. This is so that the top 2 circles aren't covering the hole.
|
Now I finished the sketch and extruded the break bracket by a 0.4 of an inch.
Next I finished the sketch and extruded the circles outward from the break bracket by a 0.11 of an inch.
Lastly I finished the sketch and extruded the circles through the break bracket.
ITS FINISHED
|
What I learned
I learned how to use the dimension tool a lot better and how to extrude a little bit better. I also learned how to use the tangent tool to connect 2 circles with a line. Lastly I learned how to use the cut tool to cut irrelevant things to an object.